5 Reasons Why Waterjet Cutting Is The Right Choice for Your Next Metal Fabrication Project

Before you look for waterjet cutting services Florida, think about if waterjet cutting is the best option for you. Water jet cutting has been increasingly popular as a cutting process for a number of tasks throughout the years. Waterjet cutting, when compared to other cutting methods, produces cleaner results, more precision, and lower costs while avoiding some of the downsides associated with other procedures, such as thermal distortion and rough finished edges.

Is water jet cutting a viable option for your project? Here are five reasons why you should think about it!

What is Water Jet Cutting?

You're probably looking for waterjet cutting services Florida right now. But do you have any idea what it is? Water jet cutting is a cold cutting technique that uses a high-pressure water jet to remove metals and other materials from one another. This can be done with either specially treated water or an abrasive chemical with sand added to it.

What Are the Advantages of Waterjet Cutting?

1. There Are No Material Restrictions

Waterjet cutting can cut almost any material, including composites, plastics, metals, glass, stone, rock, ceramics, and rubber. A granular abrasive can be added to a waterjet cutting machine to produce quality cuts on materials up to 200 mm thick. Metals are the most common materials cut by a waterjet (especially aluminum, considering its relatively soft and cuts quickly).

2. There Are No Chemicals or Heat Involved

This is a cold cutting procedure since it only employs water and granite to erode the material, and any heat generated by the erosion process is promptly cooled by the water stream. As a result, bending, distortion, and material hardening that are common with laser, plasma, and machining are reduced, reducing the requirement for secondary processing.

It is also safer for operators and the environment because it emits no vapour or smoke, and any dust particles generated by the erosion process are contained in the water and properly filtered out afterwards.

3. There Is Very Minimal Fixturing 

Cutting a single chip, some CNC machines require extensive setups with complicated fixturing that might take hours to install and calibrate. In contrast, the water jet requires relatively little fixturing and may be put up and running in minutes rather than hours.

Whether you need to cut a little bit from an existing remnant or a huge sheet of material, the water jet usually only requires a few clamps and weights for brackets to keep the material in place. It's only a question of setting zeroes and loading a programmed after that. An experienced operator can complete the process in a matter of minutes, saving you money on setup.

4. Waterjets Are Friendly to the Environment

Waterjets generate very little harmful waste. This, in turn, aids in the reduction of waste disposal expenses.

Waterjets also use less water than you might think because the water is recycled in a closed-loop system. The majority of waste water is clean enough to filter and dispose of down the drain.

5. It Stacks Cuts Like There's No Tomorrow

Stack cutting (stacking numerous sheets of material and cutting them all at once) is possible with water jet cutting equipment up to 8 inches thick. This is an excellent approach to quickly and efficiently make a large number of pieces.

Now that you know what waterjet cutting is and why it's a good fit for your next metal fabrication project, search for custom metal fabrication Florida to discover a water jetting business near you.